Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
10. 3-Points version
4
10.1. Description
1. Height adjustment knob
2. Release lever
3. Optional stops (front and rear of the unit)
4. Force adjustment knob
5. Measurement probes (depending on measurement range)
6. Height adjustment comparator
10.2. Adjusting measurement force
•
Set the measurement force using the force setting knob (4), never change
the force setting during a measurement procedure (PRESET and workpiece
measurements).
•
Adjusting measurement as indicated in chapter 5
10.3. Use
•
Set the measurement height using the height measurement knob (1)..
•
Release the measurement probes using the release lever (2).
•
Place the workpiece on the table
•
Release the measurement probes, the workpiece will be centred automatically
by the probes.
•
If necessary repeat the procedure until the workpiece is correctly positioned.
Note
The axis return run may be limited using the optional stops (3).
3
2
5
1
21
6
E
Quicklinks ausblenden:
Werbung
Inhaltsverzeichnis
