Operation; Storage; Moving The Trolley/Caddy; Filling The Trolley/Caddy - CEMO Trolley 100l Betriebsanleitung

GB

5. Operation

5.1 Storage

Important!
Material damage (deformation) of
the tank from excessive heating or
mechanical overload.
• do not expose the high-grade plastic tank to
direct sunlight for extended periods either dur-
ing transport on the vehicle or when
in storage.
Suitable storage conditions:
• ambient temperature: -10 °C to +40 °C
(cover when storing outdoors)
• Floor: level and smooth
(without pointed projections)

5.2 Moving the trolley/caddy

i
Important!
The completely filled trolley/caddy is
heavy.
Note that considerable downhill forces
arise on steep slopes.

5.3 Filling the trolley/caddy

Place the trolley/caddy in a horizontal position
and remove the screw cap.
Fill the container through the filling opening
The caddy 60 l (10873) has on both sides a
scale for normal mixing ratios. Fill the empty
container to the mark with concentrate and add
water to the "max".
After filling, close the filling open tightly again
with the screw cap a.
Also close the ventilation cap in the screw cap.
Contamination of the container must be
removed immediately with a dry cloth.
10
5.4 Transporting
During transport, observe the pertinent
regulations for transport and securing loads,
in particular:
• Road traffic (licensing) act of the country in
question,
• CEN 12195 Parts 1 to 4 for calculation and
lashing.
For fastening on the transport vehicle by means
of suitable tension belts, lay the tension belts in
the integrated recesses k on the tank.
i
Important!
Positive fit before traction! First, try
to positively load the equipment
(e.g. through striking the sides).
Excessive lashing forces can deform the tank
and thus damage it.

5.5 Filling

Filling is only possible on caddy 60 l (10873)
when the tank is in a vertical, standing position.
Note that excessive tensile forces on
the delivery hose may tip the trolley/
caddy
out of the vertical position.
Open the ventilation cap in the screw cap.
Open the delivery nozzle lock and insert the
delivery nozzle fully into the tank to be filled.
Operate the delivery nozzle e
(if necessary, lock with locking device)
and carry out filling operation.
Wind the pump steadily clockwise.
i
Important!
The pump is equipped with an internal
check valve. Winding counterclockwise
will cause high pressure in the pump
which may damage gaskets or the
entire pump.
i
Important!
Constantly monitor the filling process.