SOUND CONTROL MODE
Press the MODE button and choose Sound Controlled Mode (SOUND).
Press the ENTER button to select the desired sensitivity and frequency of the loops, respectively.
Please press the ENTER button again to confirm and to exit the SOUND Mode.
CLEANING AND MAINTENANCE
We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.
Replacing the fuse
If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rear panel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.
The desired sensitivity (SENS 00-31) and frequency of the loops
(Frequency = FQN 01-99) can be selected via the UP or DOWN
buttons.
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
31/32
00063808.DOC, Version 1.0