Auto Mode; Sound Control Mode; Master/Slave Mode; Blackout Mode - EuroLite LED Bar 2 RGB 27/1 Bedienungsanleitung

Flash from 00 to 99, increasing.
Please press the ENTER button to confirm and to exit the STAND ALONE Mode.
01 = Dimming
02 = Color jump
03 = Color flow
04 = Color chase
05 = Color flow 2
06 = Dreaming
07 = Fade flow
08 = Multi flow

Auto Mode

In Auto Mode the chasers are called up automatically in a continuous loop.
Press the MODE button to select the AUTO mode.
Press the ENTER button to select the desired frequency of the loops.
The desired frequency of the loops (Frequency = FQN 01-99) can be selected via the UP or DOWN buttons.
Please press the ENTER button to confirm and to exit the AUTO Mode.

Sound Control Mode

Press the MODE button and choose Sound Controlled Mode (SOUND).
Press the ENTER button to select the desired sensitivity.
The desired sensitivity (Sensit 00-99) can be selected via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to exit the SOUND Mode.

Master/Slave Mode

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED Bar 2 RGB 27/1 you can find an XLR-jack and an XLR-plug, which can be used
for connecting several devices.
This device then works as master-device and controls the slave-devices, which are to be connected to the
master-device via a stereo shielded cable. Connect the OUT-jack with the IN-plug of the next device.
Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm and to exit the SLAVE Mode.

Blackout Mode

Press the MODE button and choose BLACKOUT Mode.
Please press the ENTER button again to confirm and to exit the BLACKOUT Mode.
R00 G00 B00 F00
Speed 00 Flash 00
Speed 00 Flash 00
Speed 00 Flash 00
Speed 00 Flash 00
Speed 00 Flash 00
Speed 00 Flash 00
Speed 00 Flash 00
21/24 00052050.DOC, Version 1.1