Auto Mode; Master/Slave Mode; Sound Control Mode; Dimmer Speed (Step Response) - EuroLite LED PMC-8x30WCOB RGB MFL Bedienungsanleitung

Please press the ENTER button to confirm and to exit this mode.
Note: Under Chasers FLOW 8 and FLOW 9 there are 2 sub-programs to choose from (C1, C2). Please
press the ENTER button twice to reach the sub-programs. The desired color combinations can be selected
via the UP or DOWN buttons.
1. Static colors
2. Dream
3. Meteor
4. Fade
5. Change
6. Flow 1
7. Flow 2
8. Flow 3
9. Flow 4
10. Flow 5
11. Flow 6
12. Flow 7
13. Flow 8
C1: BLA-RGB C2: BLA-RGB
14. Flow 9
C1: BLA-RGB C2: BLA-RGB

Auto Mode

In Auto Mode, the chasers are called up automatically in a continuous loop.
Press the MODE button to select the AUTO mode.
Press the ENTER button to select the desired frequency of the loops.
The desired frequency of the loops (Frequency = FQN 01-99) can be selected via the UP or DOWN buttons.
Please press the ENTER button to confirm and to exit the AUTO Mode.

Master/Slave Mode

Press the MODE button to select the SLAVE mode. The devices set in this manner can now be controlled by
the master unit.
Please press the ENTER button to confirm and to exit the SLAVE Mode.

Sound Control Mode

Press the MODE button and choose Sound Controlled Mode (SOUND).
Press the ENTER button to select the desired sensitivity and frequency of the loops, respectively.
The desired microphone sensitivity (SENS 00-31) and frequency of the loops (FQN 01-99) can be selected
via the UP or DOWN buttons.
Please press the ENTER button again to confirm and to exit the SOUND Mode.

Dimmer speed (step response)

Press the MODE button until the display shows DIMMER.
Press the ENTER button.
You can select the dimmer speed: RESPON01 (response characteristics of LEDs) or RESPON02 (response
characteristics of halogen lamps) via the UP or DOWN button.
Confirm your choice by pressing ENTER and to exit the Mode.
RDM
With this function you can call up various submenus via RDM.
This device is RDM ready. RDM stands for "Remote Device Management" and makes remote control of
devices connected to the DMX-bus possible. ANSI E1.20-2006 by ESTA specifies the RDM standard as an
extension of the DMX512 protocol.
Blackout, red-green-blue-yellow-cyan-purple-white;
CL: RGB Flash 00 - 99
Seven color dreaming
Seven color flow
Seven color fade
Seven color change
Seven color chase in 1 direction
Seven color chase in 2 directions
Seven color chase relay in 1 direction
Seven color chase relay in 2 directions
Seven color chase from 2 sides to the middle
Seven color chase from the middle to 2 sides
Seven color chase
Seven color chase in 1 direction
Seven color chase in 2 directions
26/32 00080137.DOC, Version 1.0