Led; Symbols; Machine Features; Service Description - Protool IDC 15-2 TEC Original Bedienungsanleitung/Ersatzteilliste

Table of contents
1 Symbols ................................... 13
2 Machine features ....................... 13
3 Service description ..................... 13
3.1 Product features ........................ 13
3.2 Intended use ............................. 13
4 Safety instructions ..................... 14
4.1 Machine-related safety
instructions ............................... 14
4.2 Emission levels .......................... 14
5 Commissioning .......................... 14
5.1 Changing the battery pack .......... 14
5.2 Charging the battery pack ........... 14
5.3 Charger wall mount .................... 15
6 Settings .................................... 15
6.1 Changing the direction
of rotation ................................. 15
6.2 Changing gear ........................... 15
6.3 Fastening .................................. 15
6.4 Drilling ..................................... 15
6.5 Screw fastening and loosening ..... 15
7 Tool holder, attachments ............. 17
7.1 Tool chuck CENTROTEC CC-IP ...... 17
7.2 Auxiliary handle ......................... 17
7.3 Tool holder in drill spindle ............ 17
8 Operation ................................. 17
9 Service and maintenance ............ 18
10 Transport .................................. 18
11 Accessories ............................... 18
12 Disposal.................................... 19
13 Warranty .................................. 19
14 EU Declaration of Conformity ....... 19
1

Symbols

Warning of general danger
Risk of electric shock
Wear ear protection!
Read the instructions
Not to be included in municipal refuse
Advice or tip
►
2

Machine features

[1-1] Bit holder
[1-2] ON/OFF switch
[1-3] Right/left switch
[1-4] Gear switch
[1-5] Drilling/Fastening symbols
[1-6] Torque thumbwheel
[1-7] Clamp for attaching to the belt
[2-1] Battery pack
[2-2] Buttons for releasing the battery

[3-1] LED

Not all of the accessories illustrated or de-
scribed are included as standard delivery.
3

Service description

3.1 Product features

Your battery-powered hammer screwdriver
PROTOOL features the following character-
istic in particular:
- CENTROTEC
- System battery interface and charger for
NiCd/NiMH and LiIon battery pack
- Fully electronic torque selection and shut-
off
- Temperature protection, undervoltage
and overvoltage protection and dynamic
current limiting for protecting the ma-
chine and the battery pack
- Brushless, wear-resistant EC motor

3.2 Intended use

Battery-powered screwdrivers are suitable
for drilling metal, wood, plastics, and similar
materials, for impact drilling into masonry,
concrete and similar building materials and
for tightening and reinserting screws.
The BC 3 charger is designed for charging
the battery packs listed.
The user bears the responsibility for damage
and accidents caused by improper use.
13