Eufab AMBER IV Bedienungsanleitung Seite 15

Using the tension-relief strap
These instructions describe the use with estates and compact vehicles with a hatchback (rear door).
With boots (saloons) proceed appropriately.
Before mounting the tension-relief strap, remove dust and dirt from the upper region of the rear door
in order to prevent scratching and abrasion when travelling with the tow-bar rack.
Open the rear door of your vehicle. Guide the free end of the strap from the inside to the outside bet-
ween the rear door and the edge of the roof. Leave approximately 20 cm free between the strap anchor
and the edge of the roof. Carefully close the rear door. Make sure that the strap lies flat and straight
between the seals. Now slowly pull the strap until the strap anchor meets the panel of the roof liner
and the rear door.
Make sure that any roof edge spoilers are not damaged and that the functionality of the tension-relief strap is not influenced by
such spoilers.
Now attach the lock section of the strap to the U-bar as shown on Figures 1 to 4.
Figure 1
Connect both parts of the tension-relief strap as shown on Figures 5 to 7.
Figure 5
Now pull the tension-relief strap tight.
The tension-relief strap may not cover the third braking light.
The tension-relief strap may not influence the functionality of the rear windscreen wipers.
In order to release the tension-relief strap, press the lock down (Figure 6, Position 1) and pull the strap out of the lock.
Figure 2
Figure 6
Figure 3
Figure 7
Tension-relief strap
Figure 4
Tension-relief strap