Eufab AMBER IV Bedienungsanleitung Seite 12

Securing the light mount to the base frame
Insert the cross-headed screws M5 x 35 with spring washers and washers, from below, through the vertical drilled holes of the lamp mount.
Insert the screws through the threaded holes on the underside at the end of the lamp mount. Tighten the screws.
2 x Cross-headed screw M5 x 35
2 x Spring washer 8.1 x 5.5 x 1.2
2 x Washer 9.7 x 5.3 x 0.9
Mounting the U-bracket
1 x U-bracket
Now fit the U-bracket onto the intended pipe sleeves. Push the lock screws M8 x 60 from the outside, through the drilled holes of the U-bracket
and the pipe sleeves. Place the washers and knob nuts M8 on the ends of the screws and tighten the knob nuts firmly.
Mounting the frame holder
1 x Frame holder, wheel-to-wheel
1 x Frame holder, long
2 x Frame holder, short
Undo the handle screw of the frame holder and rotate out fully. Open the cuff of the frame holder and place the inserts around the U-bracket
at a position suitable for your bicycle. Place the cuff around the inserts and push firmly together. Close the frame holder using the handle screw
(but do not tighten).
The wheel-to-wheel frame holder is only required when you secure a fourth bicycle to the rack.
Mounting the license plate holder
1 x License plate holder
Remove the screws from the lamp mount of the license plate holder before mounting. Insert the screws through the vertical slots of the license
plate holder (see picture). Start the screws at the threaded holes of the lamp mount, but do not tighten yet. Align the license plate folder so
that it is at the same height as the rear lights. Now tighten the screws.
2 x Knob nut M8
2 x Washer 15.8 x 8.5 x 1.1
2 x Lock screw M8 x