Eufab AMBER IV Bedienungsanleitung Seite 13

Inserting the license plate
The mounting clips for securing the license plate are push-out parts in the holder. Break out two of
the clips. Slide the license plate into the holder, then push the clips into the cut-outs to secure the
license plate.
Laying electrical cables
Attaching the plastic covers
4 x Plastic cover
Mounting the short tensioning straps
8 x Tensioning strap, short
Insert the short tensioning strap from the inside to the outside below the bike holder and then from the outside to the inside through the slots
of the bike holder (see picture).
Mounting the bicycle rack on the trailer tow bar
Ensure that the trailer tow bar is undamaged, clean and free of
grease.
Before you put the bicycle rack on the trailer tow bar, familiarise
yourself with the quick locking system.
The quick locking mechanism is a component with a lever. Activating
the lever opens or closes the quick locking mechanism. With the help
of the securing bolt and the padlock, the quick locking system may be
locked and secured.
The padlock must always be used as additional security
when using the bicycle rack.
Lay the cables along the tube of the base frame. The cables may not be bent, stretched or crushed, e.g. in the
vicinity of the folding mechanism. Secure the cables with the supplied cable ties. When you are finished, trim any
excess material from the cable ties using cutting pliers.ab.
Fit the plastic covers onto the middle of the wheel rails.
Lock nut
Adjusting screw for
quick locking system
Clips
Cut-outs
Safety/locking pin
Lever
Lock