Eufab AMBER IV Bedienungsanleitung Seite 11

• Personal injury or property damage possible due to a damaged bicycle rack.
Damage to the rack, e.g. by bent parts, cracks or scratches, prevents the safe operation of the rack.
• Do not mount the bicycle rack if it is damaged in any way.
• Follow the steps as described in the chapter on „Maintenance".
Personal injury or property damage due to loss of the bicycle rack while driving.
A loose or faulty connection between the bicycle rack and trailer tow bar can lead to the detachment of the bicycle rack.
• Replace a defective trailer tow bar.
• Clean the trailer tow bar of dirt, dust and grease.
Personal injury or property damage possible due to loss of bicycle parts while driving.
Damaged may be caused by parts that can be lost if they come away from the bicycle during the journey.
• Remove all parts that may be lost before starting your journey, these include air pumps, batteries of electric bikes, battery-powered lamps,
navigation systems, bicycle computer, tool bags or baskets.
Personal injury or property damages caused by increase wind loads.
The bicycle rack and trailer tow bar may be damaged by too high a wind load.
• Remove all bags from the bicycle before starting your journey.
• Do not use protective covers for the bicycle during the journey.
The general operating permit must be carried in the vehicle when the rack is mounted.
Operating instructions
The bicycle rack must first be assembled. Take all of the components out of the packaging and set them out clearly. Every stage is described and
clearly shows which components are required for the assembly of the rack.
Mounting the wheel rails on the base frame
1 x Base frame
Two wheel rails form a pair. Place four pairs of wheel rails, with the plastic shells on the outside, parallel on the base frame so that the drilled
holes in the rail match the holes in the base frame. Secure each wheel rail to the base frame with the lock screws M6 x 50, 17.8 x 6.5 x 1.1
washers and self-tapping nuts M6.
Mounting the lamp mounts
1 x Lamp mounting set
Join the two halves of the lamp mount set together. This is made easier by the small guide element which is already mounted on one side.
Push the rails together and secure the connection with the cross-headed screw (M5x12), spring washer
washer 9.8 x 5.4 x 0.9.
8 x Wheel rails
Cross-headed screw M5 x 12
16 x Lock screw M6 x 50
16 x Washer 17.8 x 6.5 x 1.1
16 x Nut M6