Setting The Contact Pressure - Fronius MHP series Bedienungsanleitung

Setting the con-
tact pressure
1
1
1
3
58
NOTE! The contact pressure is set as follows:
- Turn screw clockwise = reduce the contact pressure,
maximum load moment = gently as far as stop - turn the screw until the con-
tact pressure indicator is in the 'min' position
- Turn screw anti-clockwise = increase the contact pressure,
maximum load moment = 0.4 Nm - turn the screw until the contact pressure
indicator is in the 'max' position
* Use the values shown on the illust-
ration on the inside of the cover as
a guide when setting the contact
pressure.
2
2
max.