1
5
**
***
2
1
6
****
****
Screw the cap onto the inner liner as far as it will go. The inner liner must be vis-
ible through the hole in the cap.
1
8
**
***
1
2
1
7
1
Steel inner liner
Plastic inner liner
NOTE! Steel inner liners with an
outer diameter of less than 1 mm
(0.039 in.) cannot be screwed into
the welding torch - the specified
tightening torque therefore does
not apply to these liners.
All other inner liners must be
screwed into the welding torch
and tightened to the specified
tightening torque.
53