Installation Versions - STIEBEL ELTRON DHB-E 11 SLi electronic Bedienung Und Installation

Installation
Assembly
10.2.12 Fitting the lower back panel
10.2.13 Completing the installation process
Align the mounted appliance by loosening the fixing toggle,
aligning the power supply and back panel, and then retight-
ening the fixing toggle. If the back panel of the appliance is
not flush against the wall, the appliance can be fixed with a
screw in the lower part.

10.3 Installation versions

10.3.1 Power supply from above for unfinished walls
The following diagram shows the dimensions for the power supply
from above.
To connect the power supply, take the following steps:
Open out the cable grommet to match the cross-section of
the power cable.
Push down and remove the locking hook that secures the
mains terminal, then remove the mains terminal.
Move the mains terminal in the appliance from the bottom to
the top and click into place.
26 | DHB-E SLi | A electronic
10.3.2 Power supply for finished walls
The appliance can also be connected if the power supply has been
routed over finished wall s. This applies to the connection from
below and above. Take the following steps:
Cut or break knock-outs in the back panel and appliance cap.
Possible knock-out points can be seen in the diagram "Di-
mensions for power supply".
Note
If the appliance has been connected with a power supply
on finished walls, the type of protection on the type plate
must be changed from IP 25 to IP 24. Use a permanent
marker for that.
Cross out "IP 25" and mark the box "IP 24".
10.3.3 Power supply for large cross-sections
1.
3.
If cables with a large cross-section are used, the cable grommet
can be fitted after the appliance has been installed. Take the fol-
lowing steps:
Before installing the appliance, use a screwdriver to push the
cable grommet out.
2.
4.
www.stiebel-eltron.com