Installation; Installation Information; Assembly; Installation Site - STIEBEL ELTRON DHB-E 11 SLi electronic Bedienung Und Installation

Installation

Installation
9. Installation
9.1

Installation information

9.1.1 Flow pressure
If the flow rate required for the appliance to switch on is not
achieved even with the tap fully open, remove the flow limiter.
Replace it with the plastic profile washer supplied. If required the
pressure in the water installation can also be raised.
Note
For the thermostatic valve to function correctly, the flow
limiter for this valve must not be replaced with the plastic
profile washer.
2
1 Flow limiter
2 Plastic profile washer
9.1.2 Flexible water connection lines
If the appliance is connected with flexible water connection lines,
ensure that the bayonet fittings of the pipe bends do not become
twisted inside the appliance.
9.1.3 Appliance with changeover connected load
The appliance DHB-E 18/21/24 SLi is set to 21 kW when delivered.
If the appliance is installed with a different output, take the fol-
lowing steps:
Re-plug the coding card according to the selected output; for
selectable output and fuse protection of the appliance see
"Specification".
Mark the selected output on the type plate using a perma-
nent marker.
Install the flow limiter with a rating corresponding to that of
the appliance. The colour of the flow limiter is given in the
table "Specification"
www.stiebel-eltron.com
1

10. Assembly

10.1 Installation site

The appliance is exclusively designed for installation on a solid
wall. Ensure the wall offers adequate load bearing capacity.
Always install the appliance vertically (over or undersink) in a
room free from the risk of frost.
10.1.1 Undersink
1 Cold water supply
2 DHW outlet
10.1.2 oversink
2
1 Cold water supply
2 DHW outlet
1
2
1
DHB-E SLi | A electronic | 23