Wall Mounting Bracket When Replacing An Appliance; Installation With Offset Tiles; Pivoting Appliance Cover - STIEBEL ELTRON DHB 18 STi Bedienung Und Installation

INSTALLATIoN
Alternative installation methods
13.9 Wall mounting bracket when replacing an
appliance
An existing STIEBEL ELTRON wall mounting bracket may be used
when replacing appliances (except the DHF instantaneous water
heater), as long as the fixing screw is in the lower right position.
Replacing a DHF instantaneous water heater
f Reposition the fixing screw on the wall mounting bracket (the f
fixing screw has a self-tapping thread).
f Rotate the wall mounting bracket 180° and mount it on the f
wall (the DHF logo is then turned towards you).

13.10 Installation with offset tiles

20
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance. Lock the back panel in place using f
the fixing toggle (turn 90° clockwise).
28 | DHB STi

13.11 Pivoting appliance cover

The appliance cover can be turned the other way up for undersink
installation.
f Remove the programming unit from the appliance cover by f
undoing the screws.
f Turn the appliance cover (not the appliance) the other way up f
and refit the programming unit.
f Plug the set value transducer cable into the PCB (see chapter f
"Installation / Commissioning / Initial start-up").
f Hook the appliance cover in at the top. Pivot the appliance f
cover down onto the back panel and press down until it en-
gages audibly.
f Secure the appliance cover. f
www.stiebel-eltron.com