Cocraft WLCS38A-375 Bedienungsanleitung Seite 8

Fitting the guide bar and saw chain
Note: Only use a 14" (35 cm) bar and 52-link 3/8" chain.
Warning:
• The saw chain is very sharp. Wear protective gloves.
• Only use the included guide bar or one recommended by the manufacturer. Use of other types of guide bar can lead to
personal injury or damage to the product.
1. Remove the cover (7) over the drive sprocket and clutch by first removing the two retaining nuts.
2. Place the guide bar over the two bolts and slide it
towards the drive sprocket.
4. Move the guide bar so that the chain tensioner is in its
hole in the bar.
6. Turn the chain by hand so that you can feel that it runs
freely and is sitting correctly on the drive sprocket.
8. Tighten the two retaining nuts (to a torque of 12–15 Nm).
3. Place the saw chain around the drive sprocket (25)
and into the groove in the guide bar with the links
pointing in the direction shown on the guide bar.
5. Refit the cover, hand-tighten the nuts enough for the cover
to hold the guide bar in place. If you tighten the nuts too
much you won't be able to tension the chain.
7. Tension the chain by turning the adjuster screw
clockwise. Tension the chain until it can be lifted no
more than 5 mm from the guide bar.
8