Spark Plug - Cocraft WLCS38A-375 Bedienungsanleitung

4. Carefully take the filter apart.
5. Wash the filter in petrol or soapy water and blow it clean from the inside out
with compressed air.
6. Reassemble the air filter and refit it in the reverse order.

Spark plug

1. The exterior of the saw should be wiped clean using a soft, damp cloth. Use only mild cleaning agents, never solvents or
corrosive chemicals.
2. Undo the top cover locking knob (12) and remove
the cover.
4. Remove the spark plug.
5. Clean the spark plug with a wire brush if necessary
and check that the electrode gap is 0.6–0.7 mm.
6. Replace the spark plug with a new one if necessary.
Check the gap of the new spark plug before fitting it.
3. Remove the spark plug cap from the spark plug.
15