Menu Settings - STIEBEL ELTRON SHZ 80 LCD Bedienung Und Installation

OPERATION
Settings
4.5

Menu settings

4.5.1 General menu settings principle
Note
After every adjustment, the appliance switches automati-
cally to the standard display and saves the selected value.
With the menu key, you call up all infor-
mation and setting options one after the
other. The relevant symbol appears.
4.5.2 Displaying the outlet temperature
Outlet temperature symbol appears.
The current outlet temperature is dis-
played.
4.5.3 Setting the set temperature
Set temperature symbol appears.
Adjust the set temperature from 20 to
85 °C using the plus and minus keys.
4.5.4 Starting, stopping and adjusting the temperature limit
Temperature limit symbol appears.
0
Temperature limit off (factory
setting)
!
Temperature limit on
Switch the temperature limit on or off.
Adjust the temperature limit from 40 to
60 °C using the plus and minus keys.
Temperature limit on
The temperature limit symbol appears in the standard display.
The selected temperature limit is also the maximum value for the
set temperature.
Note
ECO Plus and ECO Dynamic can no longer be selected if
the temperature limit is on.
30 | SHZ LCD
4.5.5 Displaying and adjusting ECO mode
Note
In commercial mode (see chapter "Energy saving settings
in the standard display / Commercial mode"), the ECO
settings are skipped.
ECO mode symbol appears.
The current mode is displayed.
Scroll to the required ECO mode.
ECO1
ECO2
ECO3
ECO Comfort ECO1
This energy saving mode always offers you the maximum amount
of hot water and therefore maximum comfort.
ECO2
ECO Plus
This energy saving mode offers you the advantage of energy sav-
ings, as reheating is only carried out after a significant volume of
DHW is drawn off.
ECO3
ECO Dynamic
This energy saving mode allows you to achieve maximum energy
efficiency through intelligent dynamic matching to your draw-off
patterns.
4.5.6 Displaying the energy consumption
Energy consumption symbol appears.
An approximate value for the current en-
ergy consumption is displayed.
To reset the value to zero, hold the key
for longer than 3 seconds.
hold
4.5.7 Displaying the level of scale build-up, switching
automatic indications in the standard display on/off
Scale build-up symbol appears.
The current level of scale build-up is dis-
played.
-- No / low scale build-up
CA
Descaling of the flanged immersion
heater recommended
!
Automatic indication in the standard
display on (factory setting)
0
Automatic indication in the standard
display off
Switch automatic indications in the
standard display off or on.
ECO Comfort
ECO Plus
ECO Dynamic
www.stiebel-eltron.com