Settings; Controls And Standard Display; Energy Saving Settings In The Standard Display - STIEBEL ELTRON SHZ 80 LCD Bedienung Und Installation

OPERATION

Settings

4. Settings
4.1

Controls and standard display

9
e l c t r o e l c t r o n i c
8
7
6
5
1 ECO mode symbol
2 Plus key
3 Minus key
4 Mixed water volume in l display
5 Radiator symbol
6 Rapid heating key
(in dual circuit or manual rapid heat-up operation)
7 Heat-up symbol
8 Menu key
9 Mixed water volume symbol
4.1.1 Mixed water volume display
Note
If you have adjusted the set temperature to less than
40 °C, the selected set temperature is displayed rather
than the mixed water volume.
The currently available mixed water volume at
40 °C and at 15 °C cold water temperature is
shown.
If there is currently less than 10 l mixed water
available, "< 10 l" is shown.
DHW demand for
Bath
Shower
Hand washing
The mixed water volume that can be achieved is dependent on the
cylinder size and the selected set temperature.
www.stiebel-eltron.com
1
c o m f o r t m f o r t
2
3
4
Bê ¼® | ¼ ù ¼ | Ô ³
120-150 l
30-50 l
2-5 l
4.1.2 Heat-up symbol
The symbol appears when the appliance is heating up water.
4.2

Energy saving settings in the standard display

4.2.1 ECO mode symbol
ECO Comfort (factory setting)
This energy saving mode always offers you the maximum amount
of hot water and therefore maximum comfort.
ECO symbol appears.
In ECO Comfort energy saving mode, the set tem-
perature is automatically reduced to 60 °C if a
higher set temperature is selected:
- 1 week after commissioning
(factory setting: 85 °C)
- 1 week after selecting a set temperature
above 65 °C
You can switch on this mode straight after commissioning by set-
ting the set temperature to 60 °C or lower (see chapter "Standard
settings / Setting the set temperature").
ECO Plus (with single circuit operation)
This energy saving mode offers you the advantage of energy sav-
ings, as reheating is only carried out after a significant volume of
DHW is drawn off.
ECO symbol flashes
The set temperature is automatically set imme-
diately to 60 °C.
In ECO Plus mode, the appliance heats up auto-
matically to the set temperature once you have
drawn off approx. 40 % of the cylinder content.
You can select this mode in the menu (see chapter "Menu settings
/ Displaying and adjusting ECO mode").
Note
If you change the set temperature in ECO Plus mode, the
appliance switches automatically to ECO Comfort mode.
SHZ LCD | 27