P2.0: Entering The Area Of The Air Outlet In Cm; P3.0: Rh Offset (Wöhler Fa 430 Only) - Wohler FA 410 Bedienungsanleitung

Settings
6.2

P2.0: Entering the area of the air outlet in cm

Fig. 15: Entering the area
6.3 P3.0: RH offset (Wöhler FA 430 only)
If an offset value is entered, the fan anemometer fundamentally adds the entered offset
value to the measured value.
Fig. 16: Setting the offset value
54

In the P2.0 mode, press the HOLD/MIN/MAX
key to access the Area entry mode.
A five-digit figure is displayed. The first digit flas-
hes.

Set the first digit using the Up key.

Move to the next digit using the Down key. Set
this digit as described above.

When you have finished setting the figure,
press the HOLD/MIN/MAX key to save the en-
try and return to the P2.0 mode.

In the P3.0 mode, press the HOLD/MIN/MAX
key to access the Offset setting mode.
The offset value will now flash in the display

Using the Up and Down keys, set an offset
value between 0 and 12% RH.

Move to the next digit using the Down key. Set
this digit as described above.

To return to the P3.0 mode after completing
the setting, press the HOLD/MIN/MAX key.
2 2
or inch