Entering The Absolute Pressure - Wohler IQ 300 Bedienungsanleitung

9.5 Entering the Ab-
solute Pressure
Fig. 15: Default setting „Absolute Pres-
sure"
NOTE!
At high altitudes, the pressure must be taken into
account for an accurate CO
In this case, enter the local absolute pressure
•
into the measuring device when setting up for
the first time or after a change of the location.
To do this, determine the absolute pressure at
•
the measuring location, e.g. by looking it up on
the Internet.
Default setting: „1013 hPa" is flashing in the dis-
play.
Press the ▲-key to enter the corect value.
•
(press shortly: + 1 hPa, press and hold: scroll
values). Scroll range 700 to 1990 hPa.
Confirm your selection with the ●-key or the
•
Ξ-key.
You will then automatically enter the automatic
•
calibration menu.
Table des matières
measurement.
2
EN
49