P30 Selection Of The Temperature Unit; P40 Setting The Sampling Rate - Wohler KM 410 Bedienungsanleitung

Settings
11.3 P30 Selection of
the temperature
unit
Fig. 20: Setup - Selection of the tempera-
ture unit
11.4 P40 Setting the
sampling rate
Fig. 21: Setup - Setting the sampling rate
Fig. 22: Setup - Setting the sampling rate
54
When entering the setup mode press HOLD sev-
eral times, to bring up the P30 mode for the selec-
tion of the temperature unit. "Unit" and P30 will
appear in the display.
• Press M/AVG to select the temperature unit.
• The current set and P 31 will appear on
screen.
• Press HOLD/▲or MEM/▼ to choose °C (do
not delete) or °F.
• Press M/AVG to save the settings or press
START/ESC to return to the P30 mode with-
out saving.
When entering the setup mode press HOLD sev-
eral times, to bring up the P40 mode. The user
can set a sampling rate from 1 second to 4 hours
59 minutes and 59 seconds.
• Press M/AVG to bring up the setting mode.
The hour digits will blink.
• Press HOLD/▲ to increase the value or
MEM/▼ to decrease.
• Press M/AVG to save the settings and bring
up the mode for setting the minutes.
• Proceed the same way when setting the sec-
onds.
• Press M/AVG to save the settings and to
return to the P40 mode.