Factory Settings; Installation - STIEBEL ELTRON DHE 18 SLi 25 A Gebrauchs- Und Montageanleitung

INSTALLATIoN

Installation
9.2

Factory settings

The appliances are delivered pre-prepared:
- Electrical connection from below, installation on unfinished
walls
- Water connection on unfinished walls
- For the appliance with adjustable connected load, the middle
load is preset.
10. Installation
This chapter describes installation in accordance with the factory
settings.
For further installation options, see chapter "Alternative instal-
lation methods".
f Open the appliance. f
f Remove the back panel by pressing the two locking hooks f
and pulling the lower part of the back panel forwards.
f Mark out the holes for drilling using the installation tem- f
plate. If the appliance is to be installed with water connec-
tions on finished walls, also mark out the fixing hole in the
lower section of the template.
f Drill the holes and secure the mounting bracket with f
2 screws and 2 rawl plugs (screws and rawl plugs are not
part of the standard delivery).
32 |DHE SLi
Note
If you are installing the appliance with flexible water
connections, also secure the back panel with a screw.
f Fit the mounting bracket. f
160
30
1 Installation aid
f Prepare the power cable. f
Making the water connection
Material losses
!
Carry out all water connection and installation work in
accordance with regulations.
f Seal and insert the twin connectors. f
2
1
3
24
5 Nm
5 4
1 DHW with tee
2 Gasket
3 Cold water with cross-piece
4 Strainer
5 Profile washer
f Fit the water connections. f
Material losses
!
The strainer must be fitted for the appliance to function.
f When replacing the appliance, check that the strain- f
er is present.
1
2
www.stiebel-eltron.com