Installation Site; Factory Settings; Installation - STIEBEL ELTRON HDB-E 12 Si Bedienung Und Installation

INSTALLATION

Installation
Flow pressure
If the minimum flow rate required for the appliance to switch on is
not achieved even with the tap fully open. remove the flow limiter.
Replace it with the plastic profile washer supplied. If required the
pressure in the water installation can also be raised.
2
1 Flow limiter
2 Plastic profile washer
Note
Always use a flow limiter when operating the appliance
with a thermostatic valve.
Flexible water connection lines
f If the appliance is installed with flexible water connection
lines. ensure that the pipe bends do not become twisted.
Pipe bends have a bayonet fitting and are installed inside the
appliance.
f Secure the back panel at the bottom with an additional
screw.
9.1

Installation site

Material damage
!
Install the appliance in a room free from the risk of frost.
f Always install the appliance vertically near the draw-off
point.
The appliance is suitable for undersink and oversink installations.
Note
The appliance must be fitted to a wall with sufficient
load-bearing capacity.
Undersink installation
1 Cold water inlet
2 DHW outlet
22 | HDB-E Si
1
1
2
Oversink installation
2
1 Cold water inlet
2 DHW outlet
9.2

Factory settings

The appliances are prepared in the delivered condition:
- Power supply from "below". installation on unfinished walls
- Water connection. installation on unfinished walls
10. Installation
This chapter describes installation in accordance with the factory
settings.
For further installation options. see chapter "Installation alterna-
tives".
f Open the appliance.
1
www.stiebel-eltron.com