STIEBEL ELTRON DHE 18 SLi 25 A Gebrauchs- Und Montageanleitung Seite 36

INSTALLATIoN
Installation
Wall mounting bracket when replacing an appliance
An existing STIEBEL ELTRON wall mounting bracket may be used
when replacing appliances (except the DHF instantaneous water
heater), as long as the fixing screw is in the lower right position.
Replacing a DHF instantaneous water heater
f Reposition the fixing screw on the wall mounting bracket (the f
fixing screw has a self-tapping thread).
f Rotate the wall mounting bracket 180° and mount it on the f
wall (the DHF logo is then turned towards you).
Installation with offset tiles
20
2
1
1 Minimum contact area of the appliance
2 Maximum tile offset
f Adjust the wall clearance and lock the back panel with the f
fixing toggle by turning it clockwise through 90°.
36 |DHE SLi
Pivoting appliance cover
The appliance cover can be turned for undersink installation.
electroni
c comfort
f Remove the programming unit from the appliance cover by f
pressing the locking hooks and taking out the programming
unit.
f Turn the appliance cover (not the appliance) and refit the f
programming unit, ensuring that all locking hooks click into
place. When clicking the locking hooks into place, make sure
you press against the inner side of the appliance cover (shad-
ed area).
f Plug the set value transducer cable into the PCB (see chapter f
"Commissioning / Initial start-up").
f Hook the appliance cover back in at the bottom and pivot it f
up onto the back panel.
f Ensure the all-round seal of the back panel is firmly seated f
by pushing the cover gently forwards and back.
f Secure the appliance cover. f
Operation with preheated water
By installing a central thermostatic valve you will limit the max-
imum inlet temperature (see chapter "Appliance description /
Accessories").
electroni c comfort
www.stiebel-eltron.com