Cleaning Mode Selection; Manual Driving - Philips FC8822 Bedienungsanleitung

2 The robot cleans in the auto-cleaning mode until its battery runs low. In the auto-cleaning mode, it
follows repeated sequences of Z-pattern, random, wall-following and spiral patterns (Fig. 6).
Note: To select an individual mode, press one of the mode buttons on the remote control or on the
robot (see 'Cleaning mode selection').
3 When the battery runs low, the start/stop button turns red and the robot searches for the docking
station to recharge (Fig. 15).
4 You can also press the start/stop button to interrupt or stop the cleaning run. If you press the
start/stop button again and there is still enough energy in the rechargeable battery, the robot
continues cleaning in the auto-cleaning mode.
5 To make the robot return to the docking station before the rechargeable battery runs low, press
the docking button on the remote control. All icons on the display of the robot disappear except
for the docking icon, which lights up bright blue while the robot returns to the docking station (Fig.
19).

Cleaning mode selection

Next to the auto-cleaning mode, this robot has four individual cleaning modes that can each be
activated by pressing the appropriate button on the remote control or on the robot.
Note: The manually selected modes are only active for a couple of minutes. After that, the robot
switches back to auto-cleaning mode.
Z-pattern mode
In Z-pattern mode, the robot cleans by making Z-shaped loops through the room to clean large areas
(Fig. 20).
Random mode
In this mode, the robot cleans the room in a mixed pattern of straight and crisscross movements (Fig.
21).
Wall-following mode
In this mode, the robot follows the walls of the room to give the area alongside the walls an extra
clean (Fig. 22).
Spiral mode
In this mode, the robot moves in a spiral pattern to clean a small area. If the dust detection sensor
detects dirt, the robot automatically switches the fan to turbo speed (Fig. 23).

Manual driving

1 Use the arrow buttons above and below and to the left and right of the start/stop button on the
remote control to navigate the robot through the room (Fig. 24).
Note: Be careful when you drive the robot manually close to height differences and staircases.
Note: The vacuuming function and the side brushes only work when the robot is driven forward.
The left, right or back buttons are only for maneuvering the robot.
English
11