Philips FC8822 Bedienungsanleitung Seite 17

1 Start the robot from a place somewhere in the room and not from the docking station.
2 Let the robot run until the rechargeable battery is empty to make sure that the rechargeable
battery is completely discharged before you remove it and dispose of it.
3 Undo the screws of the battery compartment lid and remove the lid (Fig. 53).
4 Lift out the rechargeable battery and disconnect it (Fig. 54).
5 Take the robot and the rechargeable battery to a collection point for electrical and electronic
waste.
Troubleshooting
This chapter summarizes the most common problems you could encounter with the appliance. If you
are unable to solve the problem with the information below, visit www.philips.com/support for a list
of frequently asked questions or contact the Consumer Care Center in your country.
Troubleshooting
Problem
The robot does not start
cleaning when I press the
start/stop button.
The robot does not clean
properly.
Possible cause
The rechargeable battery
is empty.
The bristles of one or both
side brushes are crooked
or bent.
The filter in the dust
container is dirty.
The suction opening in the
bottom of the dust
container is clogged.
The front wheel is jammed
with hair or other dirt.
The robot is cleaning a
very dark or shiny surface,
which triggers the drop-off
sensors.This causes the
robot to move in an
unusual pattern.
Solution
Charge the rechargeable battery.
Soak the brush or brushes in warm water for
a while and let them dry on a flat surface
before you mount them on the robot again.
If this does not restore the bristles to their
proper shape, replace the side brushes (see
'Replacing the side brushes').
Clean the filter in the dust container with a
cloth or a toothbrush with soft bristles.You
can also clean the filter and dust container
with a regular vacuum cleaner at a low
suction power setting.
If brushing or vacuuming does not help to
clean the filter, replace the filter with a new
one. We advise you to replace the filter at
least once a year.
Clean the suction opening (see 'Cleaning
and maintenance').
Clean the front wheel (see 'Cleaning and
maintenance').
Press the start/stop button and then move
the robot to a lighter colored piece of the
floor. If the problem continues to occur on
lighter colored floors, please go to
www.philips.com/support or contact the
Consumer Care Center in your country.
English
17