Emptying And Cleaning The Dust Container; Ordering Accessories; Replacing The Filter - Philips FC8822 Bedienungsanleitung

6 Check the side brushes and the bottom of the robot for any sharp objects that could damage your
floor.
7 To remove the TriActive XL nozzle, insert your fingers into the slots in the bottom of the robot.
There are arrows pointing to these slots. Press the catches holding the TriActive nozzle in place
inwards to release them from the slots (1). Then pull the TriActive nozzle upward and off the robot
(2) (Fig. 42).
8 Clean the suction opening with a soft brush (e.g. a toothbrush) (Fig. 43).
9 Remove all visible dirt from the TriActive nozzle before you place it back.
10 To place the TriActive nozzle, first insert the small lugs on the front into the tiny slots on either side
of the front wheel (1). Then press the catches of the TriActive nozzle inwards to lock them into the
slots in the bottom of the robot (2). Finally, check if the nozzle can still move a few millimeters up
and down freely (Fig. 44).
11 Push the side brushes onto the shafts on the bottom of the robot again (Fig. 8).

Emptying and cleaning the dust container

Empty and clean the dust container when the dust container full indicator lights up continuously.
1 Remove the cover.
2 Pull up the handle of the dust container lid and lift the dust container out of the dust container
compartment.
Note: When you remove or reinsert the dust container, take care not to damage the blades of the
motor fan.
3 Carefully lift the lid off the dust container (1) and take out the filter (2) (Fig. 45).
4 Shake the dust container over a dustbin to empty it. Clean the filter and the inside of the dust
container with a cloth or a toothbrush with soft bristles. Also clean the suction opening in the
bottom of the dust container.
Caution: Do not clean the dust container and the filter with water or in the dishwasher.
5 Put the filter back into the dust container (1). Then place the lid on the dust container(2) (Fig. 47).
6 Put the dust container back into the dust container compartment and put the top cover back on
the robot (Fig. 48).
Caution: Always make sure the filter is present inside the dust container. If you use the robot
without the filter inside the dust container, the motor will be damaged.

Ordering accessories

To buy accessories or spare parts, visit www.shop.philips.com/service or go to your Philips dealer.
You can also contact the Philips Consumer Care Center in your country (see the international warranty
leaflet for contact details).
Replacement

Replacing the filter

Replace the filter if it is very dirty or damaged. You can order a new filter kit under type number
FC8066. See 'Emptying and cleaning the dust container' in chapter 'Cleaning and maintenance' for
instructions on how to remove the filter from the dust container and how to place it in the dust
container.
English
15