Three Needle Position Dial / Twin Needle (Optional) - Carina Power & stretch Bedienungsanleitung

Three needle position dial / Twin needle
Three needle position dial
L M R
Straight
Zig-zag
15
The needle position can be
altered with the "Three needle
position dial". For normal work,
the needle position is middle. For
edge stitching or sewing parallel
lines of top stitch, select needle
position left or right.
A. Left needle position
B. Middle needle position
C. Right needle position
Twin needle (Optional)
- For twin needle sewing, insert
the extra spool pin (include with
the accessories) into the hole
on top of the machine. (See
page 5 and 6)
- Make sure that the two threads
used to thread the twin needle
are of the same weight. You can
use one or two color.
- Insert the twin needle in the
same way as single needle. Flat
side of needle should face away
from you.
- Thread each needle separately.
- When sewing with twin needle,
always proceed slowly, and
make sure to maintain a low
speed to insure quality stitching.
Attention:
Use needle position "Middle"
only. The stitch width should
not be more than "3". For
s a f e t y ' s s a k e , t u r n t h e
handwheel to check that the
needle does not go into the
stitch plate.