Walking Foot (Optional) - Carina Power & stretch Bedienungsanleitung

Attaching head
Needle
screw & clamp
Presser foot bar
Presser bar attaching screw
Walking foot
Fork arm
* The walking foot accessory is optional. It is
not included with this machine.
Always try to sew first without the walking
foot accessory which should be used only
when necessary.
It is easier to guide the fabric and you have a
better view of the seam when using the
standard, regular foot on your machine. Your
sewing machine offers excellent stitch quality
Needle bar
on a wide range of fabrics from delicate
chiffons to multiple layers of denim.
Fork arm
The "Walking foot" accessory equalizes the
feeding of the upper and lower layers of
fabric and improves the matching of plaids,
stripes and patterns. This foot helps to
prevent uneven feeding of very difficult
fabrics.
Needle
1. Lift the presser foot bar.
2. Remove the "foot holder" by opening
3. Attach the "walking foot" to the machine in
4. Make sure both the "needle screw" and
5. Draw the bobbin thread up and place both
22
Needle position
Any
counter clockwise the presser bar
attaching screw.
the following way.
I) The fork arm should fit into the needle
screw and clamp.
ii) Slide the plastic 'attaching head' from
your left to right so that it is fitted into
the "presser foot bar"
iii) Lower the 'presser foot bar'.
iv) Replace and tighten clockwise the
"presser bar attaching screw"
the "presser bar attaching screw" are
tightly secured.
the bobbin thread and the needle thread
behind the walking foot attachment.
<Optional>
Stitch width Stitch length
Any 1~4