Patch Work; Applique - Carina Power & stretch Bedienungsanleitung

Patch work

To join two pieces of fabric while
leaving a space between their
edges.
- Fold over the edges of the two
- Stitch along the edge, pulling both
- Use thicker than normal threads
- After sewing, remove the basting

Applique

- Set stitch width and length dial as
- Cut out the applique design and
- Sew slowly around the edge of the
- Trim excess material outside the
- Remove the basting thread.
- Tie top and bottom thread under
18
Needle position Stitch width Stitch length
Middle
pieces of fabric for the hem and
baste the edges to a thin piece of
paper leaving a small space
between them.
threads slightly when beginning to
sew.
for sewing.
and the paper. Finish by tying
knots on the reverse side at the
beginning and the end of the
seams.
Needle position Stitch width Stitch length
Middle
illustrated.
baste it to the fabric.
design.
stitching. Make sure not to cut any
stitches.
the applique to avoid unraveling.
3~5 1~4
1~5 0.5~1