Zipper Foot; Button Sewing Foot - Carina Power & stretch Bedienungsanleitung

Zipper foot

Button sewing foot

Needle position Stitch width Stitch length
Middle
The zip foot can be inserted right or
left, depending on which side of the
foot you are going to sew.
To sew past the zip pull, lower the
needle into the fabric, raise the
presser foot and push the zip pull
behind the presser foot. Lower the
foot and continue to sew.
It is also possible to sew in a length
of cord, into a bias strip to form a
"welt".
According to thickness of fabric to
set stitch length control.
Needle position Stitch width Stitch length
Left or Right
Install the darning plate. This will cover
the feeddog and the stitch length will
be disabled
Position the work under the foot. Place
the button on the marked position,
lower the foot, adjust stitch width to "0"
and sew a few securing stitches.
Adjust the stitch width
button . Turn the handwheel to check
that the needle goes cleanly into the
left or right hole of the button, and sew
on the button. Adjust the stitch width to
"0" and sew a few securing stitches.
If a shank is required, place a darning
needle on top of the button and sew.
For buttons with 4 holes, sew through
the front two holes first, push work
forward and then sew through the
back two holes as described.
17
0
Any
.
according to the
1~4
0