Responsibilities Of The User - Abicor Binzel WH Betriebsanleitung

WH and WHPP
1 Identification
1.1 CE marking

1.2 Responsibilities of the User

The Welding torch system WH/WHPP is used in industry and in the trade for
inert gas welding using inert gases (MIG) or active gases (MAG). It allows the
torch neck to be easily changed either manually or automatically. The
automatic change is done in connection with the ATS rotor. This series can be
used in all welding positions. Depending on the model, the welding torch is
either air- or liquid-cooled. The liquid-cooled model requires a re-circulating
cooling unit. These operating instructions only describe the Welding torch
system WH/WHPP. The welding torch system may only be operated with
original ABICOR BINZEL spare parts.
This device fulfils the requirements of the relevant EU directives.
Conformity is confirmed by the CE marking on the device.
• Keep the operating instructions within easy reach at the device for
reference and enclose the operating instructions when handing over the
product.
• Putting into operation, operating and maintenance work may only be
carried out by qualified personnel. Qualified personnel are persons who,
based on their special training, knowledge,
experience and due to their knowledge of the relevant standards, are able
to assess the tasks assigned to them and identify possible dangers (in
Germany see TRBS 1203).
• Keep other persons out of the work area.
• Please observe the accident prevention regulations of the country in
question.
• Ensure good lighting of the work area and keep the work area clean.
• Occupational health and safety regulations of the country in question. For
example, Germany: Protection Law and the Company Safety Ordinance
• Regulations on occupational safety and accident prevention
1 Identification
EN - 3