Abicor Binzel WH Betriebsanleitung Seite 40

6 Putting into operation
1 Motor control (wire feed unit)
2 Push motor
3 Feed block
Fig. 13 Parallel connection
1 Motor control
2 Push motor
3 Feed block
4 Feed rollers
Fig. 14 Control board option for resistance adjustment
EN - 16
6
M
7
8
4 Feed rollers
5 1.6 A slow micro-fuse at 24/42
VDC
ABICOR BINZEL control board option for resistance adjustment
For this connection version, the control board and the micro-fuse are installed
in the wire feed unit at a readily accessible location. The required supply
voltage is tapped, for example, at the solenoid valve connection "Shielding gas
ON/OFF" or at the "Control contactor". In some cases, a series resistance for
limiting the motor current is required.
6
M
7
8
5 Micro-fuse
6 Pull motor
7 Pull gearbox
8 Wire feed roller
Pull motor activation option
This connection version allows for a power supply of its own. The following
operating options are possible:
• Wire feed (welding)
• Wire feed (currentless)
• Wire return
5
1
2
M
3
4
6
7
8
10
1
R R
2
5 9
M
3
4
9 Control board
For other voltages, a series
transformer is required!
10 Series resistance
WH and WHPP
Pull motor
Pull gearbox
Wire feed roller