Signs And Symbols Used; Scope Of Delivery; Putting Into Operation - Abicor Binzel ABIMIG GRIP W Betriebsanleitung

4 Scope of delivery

3.2 Signs and symbols used

The following signs and symbols are used in the operating instructions:
Symbol Description
•

1
4 Scope of delivery
Order the equipment parts and wear parts separately.
The order data and ID numbers for the equipment parts and wear parts can be found in the
current catalogue or the spare parts list supplied. The contact details for advice and orders can
be found online at www.binzel-abicor.com.

5 Putting into operation

DANGER
Risk of injury due to unexpected start
The following instructions must be adhered to during all maintenance, servicing, assembly,
disassembly and repair work:
• Switch off the power source.
• Close off the gas supply.
• Close off the coolant supply.
• Disconnect all electrical connections.
DANGER
Risk of injury and device damage when handled by unauthorized persons
Improper repair work and modifications to the product may lead to serious injuries and
damage to the device. The product warranty will be rendered invalid if work is carried out on
the product by unauthorized persons.
• Only qualified personnel are permitted to perform work on the device or system.
NOTICE
• Note the following instructions:
 3 Product description on page EN-4
The MIG/MAG manual welding torch is equipped upon delivery. For information about
replacing wear parts, refer to the following chapter:
 8.1 Cable assembly on page EN-12
EN - 6
Bullet symbol for instructions and lists
Cross reference symbol refers to detailed, supplementary or further information
Step(s) described in the text to be carried out in succession
®
ABIMIG GRIP W
BAL.0192.0 • 2019-03-06