Instructions For The Installation - schellenberg Smart DRIVE 10 Premium Handbuch

D INSTRUCTIONS FOR THE INSTALLATION
1. Fasten the wall mounting fitting approx. 2 - 15 cm (depending on the space) above the upper door middle part (Fig. 9).
2. Fasten the rail with the steel pin (Fig. 9).
3. Use the U-mounting brackets (A) to fasten the door drive to the rail (Fig. 9).
4. Fasten the door drive with the ceiling mounting rails on the garage ceiling (Fig. 9).
Important: The door drive must be fastened so that the rail is aligned horizontally. The ceiling mounting rail must be
attached securely.
5. Fasten the door hinge to the garage door (Fig. 10).
6. Attach the straight and curved door arm (Fig. 10).
7. Attach the unlocking cable to the carriage (Fig. 13).
8. Pull the release part and disconnect the carriage from the door drive. Perform a manual test by manually opening and
closing the door. The door must be able to move without resistance.
9. Plug the mains plug of the door drive into a suitable socket (230V / 50Hz).
Important: Ensure that your garage door drive is connected to the power supply (230V / 50Hz).

INSTRUCTIONS FOR THE INSTALLATION

1. Follow the regulations and safety standards for electrical installations of automatic gates.
2. Be sure to observe the following points to ensure the maximum degree of safety and reliability of your door drive.
3. Before commissioning your door drive, ensure that there are no obstacles in the area of the door drive.
4. Check your power supply. The values must match with the values in these operating instructions. This information can also
be found on the rating plate of the drive.
5. The electricity connection in the garage must comply with local regulations.
6. The controller of the device can be damaged if the door drive has been installed incorrectly.
7. Check the completeness of all parts and accessories before the installation.
8. Read the instructions carefully.
9. Ensure that your garage door is in good condition before starting the installation. It should move lightly and without resis-
tance.
10. Observe the minimum distances during assembly as described in the drawings.
11. Use an optional light barrier for your additional safety, and check the automatic safety return regularly.
12. Follow the instructions and notes in this manual. If you are unsure about the installation, please contact our customer ser-
vice (see back cover).
29
GB