Bosch HTD 6 Serie Serviceanleitung Seite 42

en 42 | HTD 6xx, HTD 8xx | Service setting HTD 8xx
Test date
i
The test date (calibration) is set here.
1. Select "Options" in the start mask.
2. Select "Service" in the "Options" mask.
3. Enter the PIN: 835231
4. Select "Test date" in the "Service" mask.
5. Enter the date of calibration.
6. Confirm with key.
7. Press the key to access the "Service" mask.
Preview
i
The light image panel can be viewed and zero point
calibration performed here.
1. Select "Options" in the start mask.
2. Select "Service" in the "Options" mask.
3. Enter the PIN: 835231
4. Select "Preview" in the "Service" mask.
5. The "Service" mask is displayed by pressing twice on
the screen.
|
1 692 106 011 2014-06-23
Measuring instrument
i
The height measurement sensor can be switched
on/off and sensor calibration performed here.
1. Select "Options" in the start mask.
2. Select "Service" in the "Options" mask.
3. Enter the PIN: 835231
4. Select "Measuring instrument" in the "Service" mask.
5. Select as follows for switch-on or switch-off:
$
Manual - Switch-off (without measurement
sensor)
$
Sensor – Switch-on
6. The key resets the settings.
7. Sensor calibration can be performed with the
key. Follow the instructions on the screen to perform
calibration.
8. Press the key to access the "Service" mask.
Robert Bosch GmbH