Bosch HTD 6 Serie Serviceanleitung Seite 37

11. The laser cross must coincide with the vertical and
horizontal reference lines.
12. If this is not the case the camera must be adjusted.
This involves unfastening the display unit.
13. Adjust the position of the camera with an Allen key
until the laser cross coincides with the reference
lines.
14. Switch on the laser visor.
Robert Bosch GmbH
Checking / calibration | HTD 6xx, HTD 8xx | 37
.
15. Align the laser line of the visor in parallel with the
calibration triangle.
16. If the laser line is not parallel, turn the adjusting
screw until the alignment is correct.
en
|
1 692 106 011 2014-06-23