Bosch HTD 6 Serie Serviceanleitung Seite 41

7. Set the tolerances.
$
T.O.D.: Tolerance, right
$
T.O.S.: Tolerance, left
$
T.V.U.: Tolerance, up
$
T.V.D.: Tolerance, down
$
L.MAXX: Maximum intensity value
$
L.min: Minimum intensity value
$
D.L.: Tolerance for difference in % between right
and left headlamp intensity
8. Confirm with key.
9. The key resets the settings.
10. Press the key to access the "Service" mask.
Calibration
Refer to Section 3.4
Unit
i
The unit for the measured values to be used for
headlamp assessment is specified here.
1. Select "Options" in the start mask.
2. Select "Service" in the "Options" mask.
3. Enter the PIN: 835231
4. Select "Unit" in the "Service" mask.
5. The key is used to select the test standards for
which the unit is to be set.
$
ECE
$
SAE
$
VOR
$
VOL
6. The key is used to select the headlamps for
which the unit is to be set.
$
- Dipped beam
$
- Main beam
$
- Fog lamps
7. Set the desired unit.
8. Confirm with key.
9. The key resets the settings.
10. Press the key to access the "Service" mask.
Robert Bosch GmbH
Service setting HTD 8xx | HTD 6xx, HTD 8xx | 41
Touch cal.
i
The touch screen is calibrated here.
1. Select "Options" in the start mask.
2. Select "Service" in the "Options" mask.
3. Enter the PIN: 835231
4. Select "Touch cal." in the "Service" mask.
5. Calibration is performed with three selected points.
Each point has to be clicked onto three times.
6. The "Service" mask appears following calibration.
en
|
1 692 106 011 2014-06-23