Pressure Relief Procedure; Initial Operation - Storch HVLP SmartFinish Bedienungsanleitung

Pressure relief procedure

Observe the pressure relief procedure if you see this sym-
bol.
This device is pressurised until the pressure is manually
relieved. Comply with the pressure relief procedure once

Initial operation

Make sure the spray gun is switched off and disconnected
from the socket. See spraying device operating manual for
spraying device adjustment.
Connecting the gun to the vacuum cup
1. Connect the air hose of the spraying device to the gun
input.
2. Fill the cup by 3/4. Attach the lid. Engage the gun cup
lid to secure it to the vacuum cup.
Operation
Adjusting the spraying pattern
1. Adjust the air cap to the position for the desired
spraying pattern.
2. Check whether the trigger slider is in spraying position
(E) and not in needle removal position (D).
Translation of the original instruction
the spraying process has been completed and observe cle-
aning, testing and maintenance instructions to prevent
severe injuries caused by pressurised substances penetra-
ting the skin, spilling substances and moving parts.
The gun air supply also pressurises the spray gun cup.
Switch off the gun air supply before removing the conta-
iner to prevent the risk of severe injuries caused by pres-
surised substances or accidental spraying from the gun.
Pull the spraying device connector from the socket.
1
1
2
112
2