Component Designation; System Preparation - Storch HVLP SmartFinish Bedienungsanleitung

Component designation

Designation
A Air connection hose
B ON/OFF switch
C Nozzle compartment to store up to four nozzles
D Transport handle
E Compartment to store the power cord
F Air filter (pre-filter and main filter) for a clean air
supply to the motor
G Siphon cup gun with a capacity of 1 l
H Air filter display lights up if the air filter must be
cleaned or replaced

System preparation

Preparing the spraying substance
Filter the spraying substance before spraying; this applies
to paint, solvent and accelerator.
Use thinner with slightly slower drying characteristics for
turbine spraying systems to compensate for the reduced
drying time caused by the warm turbine air.
The capacity of the spraying device depends on the vis-
Translation of the original instruction
Designation
J Power supply cable
K Resettable overload switch
l Quick-release coupling between air hose and gun
M Air valve to shut off the air supply to the gun
N 9 m air hose
P Hose strap to store the air hose
R Storage compartment
S Cleaning container and storage area
T Storage area for siphon cup gun
cosity of the substance and the hose length. Use the hose
included in the scope of supply to prevent pressure drops.
Most substance manufacturers issue recommendations for
their substances. Observe said recommendations.
102