Tilt In Space - Leckey Mygo Max Benutzerhandbuch

Always keep the locking pin engaged
when you are not adjusting the chassis.
This will prevent the foot pedal being
operated accidentally.
Always use caution as hands could
become trapped when height adjusting
the base.
A

10.7 Tilt in space

The tilt in space can be angled while the
user is in the seat. Before you adjust the tilt
in space angle of the seat always ensure the
pelvic harness is secured preventing the user
from sliding forward in the seat.
To adjust the tilt angle pull the lever on
the push handle. Once you have selected
the angle you require, by simply removing
your hand from the handle, the chair will be
locked in position.
Please use handle bars when operating tilt
in space.
Always check with your therapist that
the use of tilt in space will not cause any
obstructions
A
10.8 Chest and Trunk
Harness Adjustment
If the child requires chest support as part
of their postural support programme the
seat will be fitted with rigid laterals or a
combination of laterals, chest harness
and trunk harness. These may need to be
adjusted on a daily basis to accommodate
differences in clothing.
Always check with your therapist as to the
optimum positioning and tensioning of the
straps and support items for the child.
To change the width of the chest harness, lift
the front cover, adjust the Velcro straps and
set to the desired width. When the correct
width has been achieved replace the cover.
Please refer to section 9.14 for specific
guidance on adjusting the trunk harness.
Always make sure the plastic buckles
are fully engaged when using the chest
harness.
Check the harness and laterals are secure
to ensure the child is safe and cannot
slide forward in the seat as this may
restrict their breathing.