Replacing The Toner Cartridge - Canon imageRUNNER ADVANCE C3330i Wartungsanleitung

Replacing the Toner
Cartridge
When there is only a small amount of toner remaining
inside the machine, a message appears on the touch
panel display. You can continue printing, but at this time
you should purchase a new toner cartridge to have it
available when needed.
When the Black toner or all of the toners run out
completely and prints can no longer be made, a
screen with instructions on how to replace the toner
cartridge appears on the touch panel display. Follow
the procedure described below to replace the toner
cartridge.
If you press [Close], you can continue operations, such as
setting modes and scanning originals, even if you do not
replace the toner cartridge immediately.
WARNING
Do not burn or throw used toner cartridges into open
)
flames, as this may cause the toner to ignite, resulting
in burns or a fire.
If you accidentally spill or scatter toner, carefully wipe
)
up the loose toner with a damp, soft cloth and avoid
inhaling any toner dust. Do not use a vacuum cleaner
that is not equipped with safety measures to prevent
dust explosions to clean up loose toner. Doing so may
cause damage to the vacuum cleaner or result in a
dust explosion due to static discharge.
CAUTION
Keep toner out of the reach of small children.
)
If toner is ingested, consult a physician immediately.
)
If toner gets onto your hands or clothing, wash it off
)
immediately with cold water. Washing it off with warm
water will set the toner, and make it impossible to
remove the toner stains.
IMPORTANT
Use only toner cartridges intended for use with this
)
machine.
For information on the supported Canon genuine
)
toner, see "Replacement Parts, " on p.39.
Do not replace toner cartridges until the message
)
prompting you to do so appears.
Do not attempt to replace the toner cartridge while
)
the machine is printing.
The colour of the toner to be replaced is displayed on
)
the touch panel display. If multiple toner cartridges
must be replaced, replace the toner cartridges in the
following order: Black, Yellow, Magenta, Cyan.
If you continue copying or printing in black-and-white
)
after cyan, magenta, or yellow toner runs out, do
not remove the depleted toner cartridges from the
machine.
You can set the machine to display a message
)
indicating that the remaining toner is low. (See
e-Manual > Settings/Registrations.)
NOTE
Complete instructions on how to replace the toner
)
cartridge can be accessed by pressing [Previous] or
[Next] on the touch panel display.
If toner runs out during a print job, the remaining
)
prints are made after you replace the toner cartridge.
If black toner is left, you can continue copying and
)
printing in black-and-white.
After replacing toner cartridges, if printed colours are
)
different from the colours printed before you replaced
the toner cartridges, perform [Auto Adjust Gradation]
in [Adjustment/Maintenance]. (See e-Manual >
Settings/Registrations.)

Replacing the Toner Cartridge

47