Replacing The Drum Unit - Canon imageRUNNER ADVANCE C3330i Wartungsanleitung

Replacing the Drum Unit

When the drum unit approaches the end of its service
life and needs to be replaced, a message appears on the
touch panel display. Follow the procedure described
below to replace the drum unit. The following example
describes the replacement procedure for drum unit 4.
IMPORTANT
For high-quality printouts, when replacing the drum
)
unit we recommend using a Canon drum unit.
Store drum units in a location away from light sources
)
such as direct sunlight.
Storing the drum unit in a room that is cold but
)
rapidly heated, or has other rapid temperature
changes, causes water droplets (condensation) to
form inside it.
Do not remove the orange protective cover until you
)
insert the drum unit into the machine.
NOTE
Complete instructions on how to replace the drum
)
unit can be accessed by pressing [Previous] or [Next]
on the touch panel display.
Depending on your contract, a message prompting
)
you to replace the drum unit may appear on the
bottom of the touch panel display. Only the drum
unit that needs to be replaced can be selected on the
touch panel display. Do not replace drum units that
cannot be selected.
52

Replacing the Drum Unit

▼
When the front cover of the main unit is closed after
)
replacing the drum unit, initialization of the drum unit
starts automatically. If multiple drum units need to be
replaced, do not close the front cover of the main unit
until all of the drum units are replaced.
When you finish replacing the drum unit, press [Close].
)
01
Open the front cover of the main unit.
02
Open the cover of the drum unit.