Settings; Acoustic Signals; Child Lock; Before First Use - Electrolux WASL2E202 Benutzerinformation

7.6 Schleudern - Essorage
Press this button to:
• Decrease the maximum speed of the
programme spin phase.
The display indicates only
the spin speeds available
for the set programme.
• Deactivate the spin phase.
• Activate the Rinse Hold option.
Set this option to prevent fabrics from
creasing. The washing programme

8. SETTINGS

8.1 Acoustic signals

The acoustic signals operate when:
• You activate the appliance.
• You deactivate the appliance.
• You press the buttons.
• The programme is completed.
• The appliance has a malfunction.
To deactivate/activate the acoustic
signals, press Optionen - Options and
Spülen + - Rinçage + at the same time for
6 seconds.
If you deactivate the acoustic
signals, they continue operate
when the appliance has a
malfunction.

8.2 Child Lock

With this option you can prevent that the
children play with the control panel.
• To activate/deactivate this option,
press Temp. and Schleudern -
Essorage at the same time until the
indicator

9. BEFORE FIRST USE

1. Connect the mains plug to the mains
socket.
2. Open the water tap.
3. Put a small quantity of detergent in the
compartment for washing phase.
4. Set and start a programme for cotton
at the highest temperature without
laundry.
comes on/goes off.
ends with water in the drum. The drum
turns regularly to reduce creasing.
The door stays locked. You must drain
the water to unlock the door.
7.7 Temp.
Press this button to change the default
temperature. When the display shows
and , the appliance does not heat the
water.
You can activate this option:
• After you press Start/Pause - Départ/
Pause : the options and the
programme knob are locked.
• Before you press Start/Pause - Départ/
Pause : the appliance cannot start.
8.3 Permanent Extra Rinse
With this option you can permanently have
an extra rinse when you set a new
programme.
• To activate/deactivate this option
press Zeit Sparen - Court and
Zeitvorwahl - Départ Différé at the
same time until the relevant indicator
comes on/goes off.
8.4 Weight sensor activating or
deactivating
To activate or deactivate the weight
sensors, press Temp. and Optionen -
Options at the same time for some
seconds.
This removes all possible dirt from the
drum and the tub.
ENGLISH 17