Frost Precautions - Electrolux WASL2E202 Benutzerinformation

26 www.electrolux.com
Always keep a rag nearby to
dry up any water spillage.
12.8 Cleaning the inlet hose and the valve filter
1.
1
2
3.
12.9 Emergency drain
Because of a malfunction, the appliance
cannot drain the water.
If this occurs, do steps (1) through (8) of
'Cleaning the drain filter'. If necessary,
clean the pump.
When you drain the water with the
emergency drain procedure, you must
activate the drain system again:
1. Put 2 litres of water in the main wash
compartment of the detergent
dispenser.
2. Start the programme to drain the
water.
3
Make sure that the impeller of
the pump can rotate. If it
does not rotate, contact the
Authorised Service Centre.
Make sure also that you
tighten the filter correctly to
prevent leakages.
2.
4.
20°

12.10 Frost precautions

If the appliance is installed in an area
where the temperature can be less than
0° C, remove the remaining water from the
inlet hose and the drain pump.
1. Disconnect the mains plug from the
mains socket.
2. Close the water tap.
3. Put the two ends of the inlet hose in a
container and let the water flow out of
the hose.
4. Empty the drain pump. Refer to the
emergency drain procedure.
5. When the drain pump is empty, install
the inlet hose again.
45°