Troubleshooting - Electrolux WASL2E202 Benutzerinformation

WARNING!
Make sure that the
temperature is higher than 0
°C before you use the
appliance again.
The manufacturer is not
responsible for damages
caused by low temperatures.

13. TROUBLESHOOTING

WARNING!
Refer to Safety chapters.
13.1 Introduction
The appliance does not start or it stops
during operation.
First try to find a solution to the problem
(refer to the table). If the problem persists,
contact the Authorised Service Centre.
With some problems, the acoustic
signals operate and the display shows
an alarm code:
• - The appliance does not fill with
water properly. Start the appliance
again by pressing appliance again by
pressing Start/Pause - Départ/Pause
button. After 10 seconds the door will
be unlocked.
• - The appliance does not drain
the water.
13.2 Possible failures
Problem
The programme does
not start.
•
•
•
•
Possible solution
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that the appliance door is closed.
• Make sure that there is not a damaged fuse in the fuse
box.
• Make sure that the Start/Pause has been pressed.
• If the delay start is set, cancel the setting or wait for the
end of countdown.
• Deactivate the Child Lock function if it is on.
- The appliance door is open or
not closed correctly. Please check the
door!
- The mains supply is unstable.
Wait until the mains supply is stable.
- No communication between
electronic elements of the appliance.
Switch off and switch on again. The
programme was not finished properly
or the appliance stopped too early. If
the alarm code appears again, contact
the Authorised Service Centre.
- The anti-flood device is on.
Disconnect the appliance and close the
water tap. Contact the Authorised
Service Centre.
WARNING!
Deactivate the appliance
before you do the checks.
ENGLISH 27