Daily Use; Loading The Laundry - Electrolux WASL2E202 Benutzerinformation

18 www.electrolux.com

10. DAILY USE

WARNING!
Refer to Safety chapters.
10.1 Using weight sensors
For a correct use of the
weight sensor, the drum
must be empty when
activating the appliance.
Set the programme BEFORE
you put the laundry in the
drum.
10.2 Before activating the
appliance
1. Connect the mains plug to the mains
socket.
2. Open the water tap.
10.3 Activating the appliance
and setting a programme
1. Press button Auto Off to activate the
appliance.
2. Turn the programme knob to the
necessary programme.
The programme indicator comes on.
The indicator of Start/Pause - Départ/
Pause button flashes with red colour.
The display shows the default temperature
and spin and the empty indicator bars of
the available functions.
3. If it is necessary, press Temp. button
and Schleudern - Essorage button to
change the water temperature and the
spin speed.
4. If necessary, press the related buttons
to add some functions or to set a
delayed start.
The display shows the symbol of the set
function and the digit shows the delayed
time.

10.4 Loading the laundry

1. Open the appliance door.
The display shows the maximum load for
the programme
laundry
and the weight of the
.
2. Put the laundry in the drum, one item
at time. Shake the items before you
put them in the drum.
On the display the weight of the laundry
updates by steps of kg 0.5. The weight is
indicative and changes with the type of
the laundry.
If you put in the drum more
laundry than the maximum
load, the symbol
the value
You can wash your laundry
but the water and energy
consumption increase.
To have the best
consumption and washing
performance remove some
items until the symbols stop
to flash.
The overload indication is
available only for
programmes with a maximum
load lower than the appliance
maximum load.
3. Close the door.
The value near the symbol
display shows the quantity of the
detergent to use.
This data is indicative and refers to the
detergent quantity for a maximum load
that the manufacturer recommends.
4. Make sure that no laundry stays
between the seal and the door.
There is a risk of water leakage or damage
to the laundry.
and
start to flash.
on the