Delay Start; Settings; Acoustic Signals; Child Lock - Electrolux WAGL4T300 Benutzerinformation

At firth touch the appliance
proposes the default setting
of the washing programme
again.
7.10 Steam Finish
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The indicator
during steam phase.
This option can increase the
programme duration.
When the programme stops the display
shows a zero
steady on and the indicator
flashing. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any

8. SETTINGS

8.1 Acoustic signals

To deactivate the acoustic signals when
the programme is completed touch the
and the
about 3 seconds.
The acoustic signals, they
continue operate when the
appliance has a malfunction.

8.2 Child Lock

With this option you can prevent that the
children play with the control panel.
• To activate/deactivate this option,
touch the
simultaneously until the indicator
comes on/goes off on the display.
You can activate this option:
• After you touch the Start/Pause
button: all the buttons and the
programme dial are deactivated
(except On/Off button ).
flashes on the display
, the indicator is
starts
buttons simultaneously for
and the buttons
button the anti-crease movements stop
and the lid unlocks.
A small laundry load helps to
reach better results.

7.11 Delay Start

With this option you can delay the start of
a programme in a more convenient time.
Touch the button repeatedly to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
After touching the Start/Pause button,
the display shows the indicator
the selected delay time and the
appliance begins the countdown.
7.12 Start/Pause
Touch the Start/Pause button to start,
pause the appliance or interrupt a
running programme.
• Before you touch the Start/Pause
button: the appliance cannot start.
The appliance keeps the selection of this
option after you switch it off.
8.3 Soft Plus
Set the Soft Plus option to optimise the
fabric softener distribution and improve
the fabric softness.
It is suggested when you use the fabric
softener.
This option increases slightly
the programme duration.
To activate/deactivate this option touch
the button and the
simultaneously until the
comes on/goes off above the
indicator.
ENGLISH 17
and
button
indicator