Settings - Electrolux WASL5T300 Benutzerinformation

20 www.electrolux.com
10.9 Skipping phase button
(Options)
By touching this button you can set:
• Only Rinse
performs only the rinsing phase , the
spinning and the draining phases of
the selected programme.
• Only Spin
performs only the spinning phase of
the selected washing programme.
• Only Drain
performs the only draining phase of
the selected washing programme.
At firth touch the appliance
proposes the default setting
of the washing programme
again.
10.10 Steam Finish
This option adds a steam phase followed
by a short anti-crease phase at the end
of the washing programme.
The steam phase reduces fabric
creasing and facilitates the fabric ironing.
The indicator
during steam phase.
This option can increase the
programme duration.

11. SETTINGS

11.1 Acoustic signals
To deactivate the acoustic signals when
the programme is completed touch the
and the
about 3 seconds.
The acoustic signals, they
continue operate when the
appliance has a malfunction.
11.2 Child Lock
With this option you can prevent that the
children play with the control panel.
• To activate/deactivate this option,
touch the
option. The appliance
option. The appliance
option. The appliance
flashes on the display
buttons simultaneously for
and the
When the programme stops the display
shows a zero
steady on and the indicator
flashing. The drum performs smooth
movements for about 30 minutes to keep
the steam benefit. By touching any
button the anti-crease movements stop
and the lid unlocks.
10.11 Delay Start
With this option you can delay the start of
a programme in a more convenient time.
Touch the button repeatedly to set the
required delay. The time increases by
steps of 30 minutes up to 90' and from 2
hours up to 20 h.
After touching the Start/Pause button,
the display shows the indicator
the selected delay time and the
appliance begins the countdown.
10.12 Start/Pause
Touch the Start/Pause
start, pause the appliance or interrupt a
running programme.
simultaneously until the indicator
comes on/goes off on the display.
You can activate this option:
• After you touch the Start/Pause
button: all the buttons and the
programme dial are deactivated
(except On/Off button ).
• Before you touch the Start/Pause
button: the appliance cannot start.
The appliance keeps the selection of this
option after you switch it off.
11.3 Soft Plus
Set the Soft Plus option to optimise the
fabric softener distribution and improve
the fabric softness.
buttons
, the indicator
A small laundry load helps to
reach better results.
button to
is
starts
and